More and more, riders are adding a T-bar to their saddle for nearly every riding style, from road riding to cross-country and downhill.

The T-bar Muni features adjustable height, length and bar-end angle via a straight 300 x 120 mm T-handle and grippy, ergonomic bar ends allowing riders to straddle the “T” for a more secure hand position for pulling. The narrow, single shaft never interferes with pedalling. A brake lever can be positioned between the bar ends or along the handle shaft.

For off-road riding, using a shorter T-bar handle reduces front saddle pressure, increases maneuvering control, and gives an ergonomic gripping position for longer rides.

We recommend this model for shorter handle extensions and more technical riding. The Muni T-bar should be used in combination with the plastic saddle handle for curved Fusion saddles (Freeride, Street, Slim). It should replace the plastic handle on the Fusion Zero saddle. See the Fusion Zero Comfort Guide for more information.

Distance riders should consider using the T-bar Distance Handle.


General
Weight: N/A
T-bar Handle: Straight 300 x 120 mm
Kit Includes: grippy ergonomic bar-ends, straight 300 x 120 mm t-bar extension, adjustable mounting bracket, saddle reinforcement plate & necessary assembly bolts.
Compatible Saddles: 2009+ Kris Holm Fusion saddles and Nimbus Gel saddles.
General setup tips
  • If the T-handle replaces the plastic handle it should be positioned very close to the front of the saddle. If it is too far extended, pulling hard on the handle while climbing standing up will shift you forward off the front of the saddle.
  • If the T-handle replaces the plastic handle, 3mm thick washers are required between the L-brackets and saddle for installation
  • If your knees bump the handle, raise it higher or cut the “T” width narrower.
  • For short handle positions, flip the tube securing the T-handle to the saddle so that the clamp faces the back. Face the clamp forwards for extended handle positions.
  • Move the T-handle closer to the saddle to increase power when pulling.
  • Extend the T-handle further from the saddle for greater support when pushing.
  • Lower the bar-end angle to increase power when pulling, or raise the bar-end angle for greater comfort when pushing.
  • A lower, less extended T-handle provides a similar riding stance to a higher more extended T-handle, but with greater control.
  • Increase the height of the front of the saddle and/or raise the T-handle position if you are falling forward in the saddle.
  • Lower the height of the front of the saddle and/or raise the T-handle position if you feel front saddle pressure.
  • Cut excess tubing off the back of the T-handle once you have finalized your handle position.

Our Commitment

Kris Holm Unicycles prides itself on producing equipment that lasts through years of long rides with minimal maintenance or repairs. Should you have any concerns about the quality of your KHU product please refer to our Warranty Policy or contact us.

Resources

T-Bar Handle Assembly Instructions pdf (192 KB)

Assembly instructions for the T-bar Touring Handle (updated to include Fusion One).

Fusion One Comfort Guide pdf (354 KB)

The Fusion One is a performance saddle. Correct setup is very important for comfort! This guide provides tips & suggested handle setups.